| 1. |
|
|
| 2. |
- Berglund, Martin, 1985-, et al.
(author)
-
Evaluation of a microplasma source based on a stripline split-ring resonator
- 2013
-
In: Plasma sources science & technology. - : Institute of Physics (IOP). - 0963-0252 .- 1361-6595. ; 22:5, s. 055017-
-
Journal article (peer-reviewed)abstract
- In this paper, a stripline split-ring resonator microwave-induced plasma source, aimed for integration in complex systems, is presented and compared with a traditional microstrip design. Devices based on the two designs are evaluated using a plasma breakdown test setup for measuring the power required to ignite plasmas at different pressures. Moreover, the radiation efficiency of the devices is investigated with a Wheeler cap, and their electromagnetic compatibility is investigated in a variable electrical environment emulating an application. Finally, the basic properties of the plasma in the two designs are investigated in terms of electron temperature, plasma potential and ion density. The study shows that, with a minor increase in plasma ignition power, the stripline design provides a more isolated and easy-to-integrate alternative to the conventional microstrip design. Moreover, the stripline devices showed a decreased antenna efficiency as compared with their microstrip counterparts, which is beneficial for plasma sources. Furthermore, the investigated stripline devices exhibited virtually no frequency shift in a varying electromagnetic environment, whereas the resonance frequency of their microstrip counterparts shifted up to 17.5%. With regard to the plasma parameters, the different designs showed only minor differences in electron temperature, whereas the ion density was higher with the stripline design.
|
|
| 3. |
- Berglund, Martin, 1985-, et al.
(author)
-
Evaluation of dielectric properties of HTCC alumina for realization of plasma sources
- 2015
-
In: Journal of Electronic Materials. - : Springer Science and Business Media LLC. - 0361-5235 .- 1543-186X. ; 44:10, s. 3654-3660
-
Journal article (peer-reviewed)abstract
- As the sensitivity of optogalvanic spectroscopy based on prototype microplasma sources increases, contamination from composite materials in the printed circuit board used starts to become a concern. In this paper, a transfer to high-temperature cofired alumina and platinum is made and evaluated. The high-purity alumina provides an inert plasma environment, and allows for temperatures above 1000A degrees C, which is beneficial for future integration of a combustor. To facilitate the design of high-end plasma sources, characterization of the radio frequency (RF) parameters of the materials around 2.6 GHz is carried out. A RF resonator structure was fabricated in both microstrip and stripline configurations. These resonators were geometrically and electrically characterized, and epsilon (r) and tan were calculated using the RF waveguide design tool Wcalc. The resulting epsilon (r) for the microstrip and stripline was found to be 10.68 (+/- 0.12) and 9.65 (+/- 0.14), respectively. The average tan of all devices was found to be 0.0011 (+/- 0.0007). With these parameters, a series of proof-of-concept plasma sources were fabricated and evaluated. Some problems in the fabrication stemmed from the lamination and difficulties with the screen-printing, but a functioning plasma source was demonstrated.
|
|
| 4. |
- Berglund, Martin, 1985-, et al.
(author)
-
Extreme-temperature lab on a chip for optogalvanic spectroscopy of ultra small samples – key components and a first integration attempt
- 2016
-
In: 27th Micromechanics And Microsystems Europe Workshop (MME 2016). - : Institute of Physics (IOP).
-
Conference paper (peer-reviewed)abstract
- This is a short summary of the authors’ recent R&D on valves, combustors, plasma sources, and pressure and temperature sensors, realized in high-temperature co-fired ceramics, and an account for the first attempt to monolithically integrate them to form a lab on a chip for sample administration, preparation and analysis, as a stage in optogalvanic spectroscopy.
|
|
| 5. |
- Berglund, Martin, 1985-, et al.
(author)
-
Manufacturing Miniature Langmuir probes by Fusing Platinum Bond Wires
- 2015
-
In: Journal of Micromechanics and Microengineering. - Bristol : Institute of Physics Publishing (IOPP). - 0960-1317 .- 1361-6439. ; 25:10
-
Journal article (peer-reviewed)abstract
- This paper reports on a novel method for manufacturing microscopic Langmuir probes with spherical tips from platinum bond wires by fusing for plasma characterization in microplasma sources. Here, the resulting endpoints, formed by droplets on the ends of a fused wire, are intended to act as spherical Langmuir probes. For studying the fusing behavior, bond wires were wedge bonded over a 2 mm wide slit, to emulate the final application, and fused with different voltages and currents. For electrical isolation, a set of wires were coated with a 4 μm thick layer of Parylene before they were fused. After fusing, the gap size, as well as the shape and area of the ends of the remaining stubs were measured. The yield of the process was also investigated, and the fusing event was studied using a high-speed camera for analyzing its dynamics. Four characteristic tip shapes were observed: spherical, folded, serpentine shaped and semi-spherical. The stub length leveled out at ~400 μm as the fusing power increased. The fusing of the coated wires required a higher power to yield a spherical shape. Finally, a Parylene coated bond wire was integrated into a stripline split-ring resonator (SSRR) microplasma source, and was fused to form two Langmuir probes with spherical endpoints. These probes were used for measuring the I–V characteristics of a plasma generated by the SSRR. In a voltage range between −60 V and 60 V, the fused stubs exhibited the expected behavior of spherical Langmuir probes, and will be considered for further integration.
|
|
| 6. |
- Berglund, Martin, 1985-, et al.
(author)
-
Microfluidics integrable plasma source powered by a silicon through-substrate split-ring resonator
- 2013
-
In: Solid-State Sensors, Actuators and Microsystems (TRANSDUCERS EUROSENSORS XXVII). ; , s. 2608-2611
-
Conference paper (other academic/artistic)abstract
- A novel microplasma source, based on a microstrip split-ring resonator design with electrodes integrated in its silicon substrate, was designed, manufactured and evaluated. This device should offer straightforward integration with other MEMS components, and has a plasma discharge gap with a controlled volume and geometry, with potential for microfluidics. Two realized devices were resonant at around 2.9 GHz with quality factors of 26.6 and 18.7. Two different plasma ignition modes were observed, where the plasma at low pressures was not confined to the gap but rather appeared between the ends of the electrodes on the backside.
|
|
| 7. |
- Berglund, Martin, 1985-, et al.
(author)
-
Microplasma source for optogalvanic spectroscopy of nanogram samples
- 2013
-
In: Journal of Applied Physics. - : American Institute of Physics (AIP). - 0021-8979 .- 1089-7550. ; 114:3, s. 033302-
-
Journal article (peer-reviewed)abstract
- The demand for analysis of smaller samples in isotopic ratio measurements of rare isotopes is continuously rising with the development of new applications, particularly in biomedicine. Interesting in this aspect are methods based on optogalvanic spectroscopy, which have been reported to facilitate both 13C-to-12C and 14C-to-12C ratio measurements with high sensitivity. These methods also facilitate analysis of very small samples, down to the microgram range, which makes them very competitive to other technologies, e.g., accelerator mass spectroscopy. However, there exists a demand for moving beyond the microgram range, especially from regenerative medicine, where samples consist of, e.g., DNA, and, hence, the total sample amount is extremely small. Making optogalvanic spectroscopy of carbon isotopes applicable to such small samples, requires miniaturization of the key component of the system, namely the plasma source, in which the sample is ionized before analysis. In this paper, a novel design of such a microplasma source based on a stripline split-ring resonator is presented and evaluated in a basic optogalvanic spectrometer. The investigations focus on the capability of the plasma source to measure the optogalvanic signal in general, and the effect of different system and device specific parameters on the amplitude and stability of the optogalvanic signal in particular. Different sources of noise and instabilities are identified, and methods of mitigating these issues are discussed. Finally, the ability of the cell to handle analysis of samples down to the nanogram range is investigated, pinpointing the great prospects of stripline split-ring resonators in optogalvanic spectroscopy.
|
|
| 8. |
- Berglund, Martin, 1985-
(author)
-
Miniature Plasma Sources for High-Precision Molecular Spectroscopy in Planetary Exploration
- 2015
-
Doctoral thesis (other academic/artistic)abstract
- The prospect of finding life outside Earth has fascinated mankind for ages, and new technology continuously pushes the boundary of how remote and how obscure evidence we can find. Employing smaller, or completely new, types of landers and robots, and equipping them with miniature instruments would indeed revolutionize exploration of other planets and moons.In this thesis, microsystems technology is used to create a miniature high-precision isotope-resolving molecular spectrometer utilizing the optogalvanic effect. The heart of the instrument, as well as this thesis, is a microplasma source.The plasma source is a split-ring resonator, chosen for its simplicity, pressure range and easily accessible plasma, and modified to fit the challenging application, e.g., by the adding of an additional ground plane for improved electromagnetic shielding, and the integration of microscopic plasma probes to extract the pristine optogalvanic signal.Plasma sources of this kind have been manufactured in both printed circuit board and alumina, the latter for its chemical inertness and for compatibility with other devices in a total analysis system. From previous studies, classical optogalvanic spectroscopy (OGS), although being very sensitive, is known to suffer from stability and reproducibility issues. In this thesis several studies were conducted to investigate and improve these shortcomings, and to improve the signal-to-noise ratio. Moreover, extensive work was put into understanding the underlying physics of the technique.The plasma sources developed here, are the first ever miniature devices to be used in OGS, and exhibits several benefits compared to traditional solutions. Furthermore, it has been confirmed that OGS scales well with miniaturization. For example, the signal strength does not decrease as the volume is reduced like in regular absorption spectroscopy. Moreover, the stability and reproducibility are greatly increased, in some cases as much as by two orders of magnitude, compared with recent studies made on a classical OGS setup. The signal-to-noise ratio has also been greatly improved, e.g., by enclosing the sample cell and by biasing the plasma. Another benefit of a miniature sample cell is the miniscule amount of sample it requires, which can be important in many applications where only small amounts of sample are available.To conclude: With this work, an important step toward a miniature, yet highly performing, instrument for detection of extraterrestrial life, has been taken.
|
|
| 9. |
- Berglund, Martin, et al.
(author)
-
Operation characteristics and optical emission distribution of a miniaturized silicon through-substrate split-ring resonator microplasma source
- 2014
-
In: Journal of microelectromechanical systems. - 1057-7157 .- 1941-0158. ; 23:6, s. 1340-1345
-
Journal article (peer-reviewed)abstract
- There are many new microplasma sources being developed for a wide variety of applications, each with different properties tailored to its specific use. Microplasma sources enable portable instruments for, e.g., chemical analysis, sterilization, or activation of substances. A novel microplasma source, based on a microstrip split-ring resonator design with electrodes integrated in its silicon substrate, was designed, manufactured, and evaluated. This device has a plasma discharge gap with a controlled volume and geometry, and offers straightforward integration with other microelectromechancial systems (MEMS) components, e.g., microfluidics. The realized device was resonant at around 2.9 GHz with a quality factor of 18.7. Two different operational modes were observed with the plasma at high pressure being confined in the gap between the electrodes, whereas the plasma at low pressures appeared between the ends of the electrodes on the backside. Measurement of the angular distribution of light emitted from the device with through-substrate electrodes showed narrow emission lobes compared with a reference plasma source with on-substrate electrodes.
|
|
| 10. |
- Bergström, Göran, 1964, et al.
(author)
-
Body weight at age 20 and in midlife is more important than weight gain for coronary atherosclerosis: Results from SCAPIS.
- 2023
-
In: Atherosclerosis. - : Elsevier BV. - 1879-1484 .- 0021-9150. ; 373, s. 46-54
-
Journal article (peer-reviewed)abstract
- Elevated body weight in adolescence is associated with early cardiovascular disease, but whether this association is traceable to weight in early adulthood, weight in midlife or to weight gain is not known. The aim of this study is to assess the risk of midlife coronary atherosclerosis being associated with body weight at age 20, body weight in midlife and body weight change.We used data from 25,181 participants with no previous myocardial infarction or cardiac procedure in the Swedish CArdioPulmonary bioImage Study (SCAPIS, mean age 57 years, 51% women). Data on coronary atherosclerosis, self-reported body weight at age 20 and measured midlife weight were recorded together with potential confounders and mediators. Coronary atherosclerosis was assessed using coronary computed tomography angiography (CCTA) and expressed as segment involvement score (SIS).The probability of having coronary atherosclerosis was markedly higher with increasing weight at age 20 and with mid-life weight (p < 0.001 for both sexes). However, weight increase from age 20 until mid-life was only modestly associated with coronary atherosclerosis. The association between weight gain and coronary atherosclerosis was mainly seen in men. However, no significant sex difference could be detected when adjusting for the 10-year delay in disease development in women.Similar in men and women, weight at age 20 and weight in midlife are strongly related to coronary atherosclerosis while weight increase from age 20 until midlife is only modestly related to coronary atherosclerosis.
|
|
